"RESET"
Flashlight Test, Silence, and Reset System

The Flashlight Test, Silence, and Reset System can be used to silence the alarm buzzer, reset the danger relay, and electronically test the detector. A flashlight beam can be directed to the "Reset" portion of the control panel from as far away as 15 feet.

You must stand directly in front of the detector. The flashlight must have a sufficient amount of brightness (a two D-cell or LED flashlight with fully charged to half-charged batteries or an equivalent rechargeable flashlight) so that the beam of light can clearly be seen on the detector itself. If the flashlight's beam cannot be seen clearly, the room light must be lowered. Lower the light in the room until the beam of light can clearly be seen on the detector.

A red confirm LED will appear when the Flashlight Test, Silence, and Rest System is activated. Never operate the detector if the confirm LED is illuminated and you are not activating the system. The confirm LED should only be illuminated by a flashlight. Do no install the detector in direct sunlight or light.

If the "confirm" LED is illuminated, but not illuminated by a flashlight, the detector must be moved to another wall location to eliminated the light source.

To avoid nuisance activation of the "confirm" light, a field adjustment can be made to correct the problem.